Solar-Wind System Est – West SW-EW
The lightest 10 ° aerodynamic system for maximum installed power on flat roof without drilling for Est - West installation
Applications
Suitable for:
- Flat roof without drilling Solar Wind
Allowable configurations:
- 1 module – lanscape disposition
Versions
- Brackets in aluminium AW 6060 T66/T5 according to UNI EN 755- 2:2013
- Screws in stailess steel A2-70 according to UNI EN ISO 3506-1/2:2010
Features
- No drilling: Solar-Wind System South does not need to drill the roof. The system is locked with small concrete ballasts.
- Quick: the installation time is about 10 minutes for kWp.
- Light: The low panels slope (10° degrees) and the carter behind the modules reduce the wind load on the system and also the number of concrete ballasts
- Complete range: the system is available for a wide range of panels (width 950 ÷ 1020 mm x height1630 x 1675 mm).
- Easy: the system is modular, allowing an extremely flexible layout panels.
- Safe: the special central clamp allows the grounding of the system.
- Designable: the number of the ballasts is calculable in according to wind load.
- Identify on the roof the position of the structures according to the project layout and the size of the modules.
- Identify the number of concrete ballasts to use for each brackes in according to wind load and snow load.
- Position on the roof the mounting brackets SW-EW B..(front, middle).
- Position the panels on the brackets SW-EW B..and fix them with clamps SW-MC e SW-MF.
- Position the concrete ballasts SW BALLAST in according to the project, protecting the roof covering with protective pads PAD SW.
- For snow load higher than 2,40 kN/ m2 use frontal brackets SW-EW BF SNOW 10° and middle brackets SW-EW BM SNOW 10°.