Single pole tree system SPTS

The hdg solution for free-fields system with 4 modules in landscape disposition

Applications

Suitable for:
Solar-Field single pole tree system with:

  • SPTS-HP and SPTS-VP profile
  • SPS-PM clamps

Allowable configurations:

  • 4 modules –  landscape disposition

Versions

  • S235JR steel according to EN 10025-2:2004, hdg (≥ 80 µm) according to EN ISO 1461:2009
  • bolts and nuts in stainless steel A2-70 according to EN ISO 3506-1/2:2009

Features

  • Free field system: the single pole tree system SPTS allows to realize photovoltaic layout of 40 panels tables (4 x 10 modules in landscape disposition).
  • Flexible: SPTS system allows to realize 4 different defined inclination (15° – 20° – 25° – 30°).
  • Easy and fast: pre-drilled piles, profiles and brackets to make easier and faster all the installation steps.
  • attention Maximum allowable spacing 2130 mm, depending on snow and wind loads calculated according current National Regulations.
  • Define SPTS structure spacing depending on snow and wind load for the effective installation area, according National Regulations.
  • Drive the single pole SPTS-SP to the required depth according to geotechnical soil test report.
  • Fasten the SPTS-IB inclined profile on the upper side of the single pole SPTS-SP using M 16 screws.
  • Fix the frontal upper bracing SPTS-FTB to the frontal bottom bracing SPTS-FBB and the rear upper bracing SPTS-RTB to the rear bottom bracing with 2 + 2 M 16 bolts.
  • Joint the frontal and rear bracing to the single pole SPTS-SP and to the inclined beam SPTS-IB with 2 + 2 M 16 bolts.
  • Reinforce the main structures with the back bracing SPTS-BB with 1 + 1 M 10 bolts.
  • Minimum thread length of M 16 screw is 35 mm, M 10 bolt is 30 mm.